Table of Contents
Advertisement
Before starting
your dishwasher
1. Spin the Upper Spray Arm to make sure
nothing
will stop it from turning
freely
2. Push door firmly when closing
and it will
automatically
latch.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn it off.
Starting your dishwasher
1.
Push a Clean
Selector
Button for the de-
sired cycle.
2. Push Option
Selector
Button for desired
option
or options.
(Use AIR DRY for RINSE
& HOLD Cycle.)
3. Turn Cycle
Control
Knob clockwise
to
point to a desired
cycle.
You will feel a
definite
stop at each cycle
mark.
CLEAN SELECTOR BUTTONS
I//
OPTION SELECTOR BUTTONS
- POTS & PANS and HEAVY WASH Cycles
share the same spot on the dial. The
Clean
Selector
Button
determines
which
cycle
operates.
The dishwasher
will automatically
start
the selected
cycle.
The AIR DRY Option
Air in the dishwasher
is automatically
heated
during
the "dry" part of all cycles.
If the AIR DRY Option
is selected,
air in the
dishwasher
is not heated.
Using this option helps
save energy, but dishes ta ke longer to dry (over-
night)
and
some
water
spotting
may
result.
Some items (such as plastics)
may need towel
drying.
For best results, use a liquid
rinse aid such as
Jet-Dry.@
HI-TEMP
WASHING
Option
When this option
is selected,
water
for the
main wash and the final rinse is heated
to145 F
(63-C).
continues
without
delay.
The WATER HEATING
If the water
is alreadv
hot enouah.
the cvcle
HOLD Signal Light will be on while the cycle
de-
lays for water heating.
Using DELAY START
4. Close
and
latch the door. The DELAY WASH
Signal
Light will come
on until the selected
cycle
starts.
NOTES:
l
You can
add
items
while
time
is counting
down. Close and latch the door. The timer will
not advance
if the door is unlatched.
l
RINSE & HOLD and LOW ENERGY WASH Cycles
can't be delayed.
1. Push desired
Clean
Selector
Button.
2. Push desired
Option
Selector
Buttons.
3. Turn Control Knob clockwise
to the number
of
hours (from 1 to 6 hours] you want the dish-
washer
to delay
before
the selected
cycle
starts.
To add a dish after
starting
4. Close the door. Do not latch
it. Wait 30 sec-
1. To be sure the added
item is washed
and
rinsed, make
sure the Cycle
Control
Knob
has not passed
LOW ENERGY WASH.
2. Unlatch the doorto
stop the cycle.
3. Open the door and add the dish.
onds for air in the dishwasher
to warm
up.
This helps
reduce
the amount
of moisture
that can come
from the vent when
restart-
ing the cycle.
5. Latch
the door.
The dishwasher
will start
from where
it stopped.
The CLEAN Signal Light
To turn it off. Turn the Control
Knob clockwise
The CLEAN Signal Light will come
on when a
slightly
until the light goes off. Do not pull out
washing
cycle
is complete.
the Control
Knob.
8
Advertisement
Table of Contents
