Lighting Instructions - COZY VC201C Installation And Operating Instructions Manual

A. This appliance has a pilot which must be
WARNING:
lighted by hand. When lighting the pilot,
If you do not
follow these instructions exactly.
follow these
B. BEFORE LIGHTING smell all around the
instructions
appliance area for gas. Be sure to smell
exactly, a fire
next to the floor because some gas is
or explosion
heavier than air and will settle on the floor.
may result
causing
WHAT TO DO IF YOU SMELL GAS:
property
• DO NOT try to light any appliance.
damage,
• DO NOT touch any electric switch;
personal
injury or loss
• Immediately call your gas supplier from
of life.
1. STOP! Read the information on the safety label.
2.
Turn temperature control knob to "OFF" or to it's
lowest position.
3.
Depress and turn gas control knob clockwise
to "OFF" position.
Gas Control Knob
Fig. J-1
4. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor. If you
smell gas, STOP! Follow "B" in the information on
the safety label. If you don't smell gas, go to the next
step.
5. Open casing door and pilot lighting hole cover.
6. Find pilot. (Follow metal pilot tube from gas control).
7. Locate red piezo ignitor button on top of heater.
8. Turn gas control knob counterclockwise
"PILOT".
1. Turn the temperature control knob to it's lowest setting.
2. Push in gas control knob slightly and turn clockwise

LIGHTING INSTRUCTIONS

MODELS:
VC201C
FOR YOUR SAFETY READ BEFORE LIGHTING
DO NOT use any phone in your building.
a neighbor's phone. Follow the gas
supplier's instructions.

LIGHTING INSTRUCTIONS

NOTE:
Knob can not
be turned from
"PILOT" to "OFF"
unless knob
is pushed in
slightly.
Do not force.
TURNING OFF GAS TO APPLIANCE
/ VC351C / VC501C
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools. If
the knob will not push in or turn by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
Pilot is located on end
of combustion chamber
above burner.
9. Push in gas control
knob and hold in.
Immediately begin a series of pushing and releasing
the red piezo ignitor button, while observing the
pilot. Continue to spark until pilot is lit. Continue
to hold the gas control knob in for about one (1)
minute after the pilot is lit. Release the gas control
knob and it will pop back up. Pilot should remain lit.
If pilot goes out, repeat steps 3 thru 9.
• If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician
or gas supplier.
10. Close pilot lighting hole cover and casing door.
11. Turn gas control knob counterclockwise
"ON".
to
12. Turn temperature control knob to desired setting.
to "OFF". Do not force.
Page 11
Back to the Index
Fig. J-2
to
1017480-A