Radio Operations; Tuning To Radio Stations; Presetting Radio Stations; Using Auto Install - Philips HTS6600 User Manual

Before you start ...
Make sure the FM and AM/MW antennas
are connected.

Tuning to radio stations

A
Press SOURCE repeatedly until 'RADIO
FM' appears on the display panel (or
press RADIO on the remote control).
B
Press cursor left/right keys briefl y on the
remote control to start tuning.
'SEARCH > or <' appears on the
display panel until a radio station with
suffi cient signal strength is found.
C
B
Repeat step if necessary until you fi nd
the desired radio station.
D
To fi ne-tune the reception of a weak
station, press the cursor up/down keys
briefl y and repeatedly until optimal
reception is found.
E
To switch between FM stereo and FM
mono mode, press AUDIO on the
remote control.
Helpful Hint:
– If the FM radio station is transmitting RDS
(Radio Data System) data, the RDS name
will be displayed and stored.

Radio Operations

Presetting radio stations

You can store up to 40 FM and 20 AM
preset radio stations in the memory.
There are three different ways to
program the radio stations:
– Using auto install (for fi rst time setup
only)
– Using automatic preset
– Using manual preset
Helpful Hints:
– This unit exits presetting mode if no
button is pressed within 20 seconds.
– If no stereo signal is detected or less than
5 (fi ve) stations are detected during radio
installation, 'CHECK ANTENNA' appears.

Using auto install

When you access the 'RADIO' mode for
the very fi rst time, you will be prompted
to install the radio stations. With this
feature, you can install all the available
radio station automatically with one
touch of button.
HDMI
A
Press RADIO.
'AUTO INSTALL ... PRESS PLAY'
appears.
RADIO
45