GE PP9830 Owner's Manual & Installation Instructions page 13

I stallatio
I structios
Radiant Downdraft Cooktop
PP9830
r_ ,,if you have questions, call 800.GE.CARES or visit our website at GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT- save t hese instructions forlocal
inspector's use.
• IMPORTANT - Observe all
governing
codes
and ordinances.
• Note to Installer - Be sure to leave these instructions
with the Consumer.
• Note to Consumer - Keep these instructions for future
reference.
• Unless very knowledgeable in the installation of this
product, engage a professional installer.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
AWARNING
- Before beginning the installation,
switch power off at the service panel and lock the service
disconnecting means to prevent power from being switched
on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
IPIPORTANT SAFETY INSTRUCTIONS
IkWARNING -TOREDUCE THE RISK
OF FIRE, E LECTRIC SHOCK OR INJURYTO PERSONS,
OBSERVE THE FOLLOWING:
[] Installation work and electrical wiring must be done
by qualified person(s)in accordance with all applicable
codes and standards, including fire-rated
construction.
r_ sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney)of fuel
burning equipment to prevent back drafting. Follow
the heating equipment manufacturer's guidelines and
safety standards such as those published by
the National Fire Protection Association (NFPA), and
the American Societyfor Heating, Refrigeration and
Air Conditioning Engineers(ASHRAE), and the local
code authorities.
[] When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
[] Ducted fans must always be vented to the outdoors.
• This unit must be properly grounded.
^_WARNING - ToREDUCE THE RISK OF
FIRE,
USE ONLY METAL DUCTWORK.
i
Z
{,t3
r-
r"
i
0
Z
i
Z
{a3
-4
C
-4
i
0
Z
{a3
EXHAUST BLOWER RATINGS
EXHAUST BLOWER SAFETY WARNING
Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney)of fuel burning equipment to
prevent back drafting. Follow the heating equipment manufacturer's guide linesand safety standards, such as those published by
the National FireProtection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning (ASHRAE)and
the local code authorities, when applicable, install any make up (replacement)air system in accordance with local building code
requirements. Visit GEAppliances.comfor available makeup air solutions.