Option 3: Connecting To A Progressive Scan Tv Or Component Video Input; Option 4: Using An Accessory Rf Modulator - Philips HTS3440 User Manual

Option 3
L
R
Option 3: Connecting to a
Progressive Scan TV or component
video input (best picture quality)
The progressive scan video quality is only
available when using Y Pb Pr connection
and a progressive scan TV is required. It
provides superior picture quality when
watching DVD movies.
A
Follow option 1 to make the basic video
connection.
B
Use the component video cables (red/
blue/green - not supplied) to connect the
Y P P jacks on the DVD system to the
B R
corresponding component video input
jacks (or labelled as Y Pb/Cb Pr/Cr or
YUV) on the TV.
C
If your TV accepts progressive signals,
proceed to 'Getting Started - Step 5:
Setting up Progressive Scan feature' for
detailed progressive feature setup.
TIPS: Before making or changing any connections, make sure that all the devices are disconnected
from the power outlet.
Basic Connections
Option 4
Antenna
L
R
Option 4: Using an accessory RF
modulator
If your TV has only a single Antenna Input
jack (labelled as 75 ohm or RF In,) you
will need an RF modulator in order to
view the DVD playback on the TV. See
your electronics retailer or contact
Philips for details about RF modulator
availability and operations.
A
Use the supplied composite video cable
(yellow) to connect the DVD system's
CVBS jack to the video input jack on the
RF modulator.
B
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT to TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
C
Connect the Antenna or Cable TV
service signal to the ANTENNA IN or RF
IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV.)
(continued)
Rear of an RF modulator
(example only)
17