Gp 5 Software Download - Xerox FaxCentre F116 Service Manual

General Procedures/Information

GP 5 Software Download

Two methods can be used to update the machine software:
• by means of a USB link to a laptop.
• by means of a local network.
The main software (that runs on the CPU board), the boot software and the PCL/SG Script font
files can be downloaded independently.
Download via PC Link
This procedure requires a laptop running under DOS or Windows and a USB cable. Perform the
following:
• Print the Machine Parameters. Press key sequence M, *, 1. The report will be used
after the upgrade.
• Change soft switch bit number 8. Press key sequence M, *, #. Select OK on SOS1.
Change bit number 8 (the far left) from 0 to 1. Press C to exit.
• Connect the USB cable from the laptop to the machine.
• Switch the machine to Upload mode. Press key sequence M, *, 4.
• Download the F116/F116L upgrade tool from the CD-ROM to the laptop or PC.
• Use the upgrade tool to browse for the firmware update. When the relevant file is
located, select Upload.
• A pop up window will appear if the upload is successful. Select OK to close the window.
Close the upgrade tool. Disconnect the USB cable.
• After 15-20 seconds the machine will reboot.
• After the machines has rebooted, a Scanner Calibration must be performed. Press key
sequence M, 8, 0. Select OK. Follow the instruction on the UI to perform the procedure.
Note: The machine will produce black prints if this procedure is not performed.
• Change soft switch bit number 8. Press key sequence M, *, #. Select OK on SOS1.
Change bit number 8 (the far left) from 1 to 0. Press C to exit.
• Print the Machine Parameters. Press key sequence M, *, 1. Ensure the firmware level is
correct, refer to the last page of the report. Also, verify that SOS1 bit number 8 (the first
number) is 0. Refer to the top of the last page.
• The machine is now ready for use.
6-30 9/04 FaxCentre F116/F116L