Timer Setting - Philips FW-V795 User Manual

1
Press and hold CLOCK•TIMER for more than
two seconds to select timer mode.
"AM 12:00" or "00:00" or the last timer
setting will start flashing.
will start flashing.
TIMER
The selected source will be lighted while
other available sources are flashing.
2
Press VCD, TUNER or TAPE to select the
desired source.
Before setting the timer, make sure the music
source has been prepared.
VCD – Load the disc(s). To start from a specific
track, make a programme (refer to "CD/VCD/
MP3-CD Operation - Programming the disc
tracks").
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 2.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK•TIMER to store the start time.
"TIMER ON" will be displayed and followed
by the set timer "XX:XX" and then the selected
source.
will remain on the display.
TIMER
At the preset time, the selected source will play.
To exit without storing the setting
Press Çon the system.
To deactivate the TIMER
1
Press and hold CLOCK•TIMER for more than
two seconds.
2
Press Çon the system to cancel the timer.
The display will show "CANCEL" and
will disappear from the display.
pg 001-035/V795/21-Eng
To activate the TIMER (for the same preset
time and source)
1
Press and hold CLOCK•TIMER for more than
two seconds.
2
Press CLOCK•TIMER again to store the start
time.
The last set timer information will be shown
for a few seconds and
the display.
Notes:
– If the source selected is VCD, playback will begin
with the first track of the last selected disc or other
trays if disc is empty. If all the disc trays are empty,
TUNER will be selected instead.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
TIMER
31
Clock/Timer
will appear on
TIMER
3139 115 21281
4/16/02, 6:44 PM
31