Table of Contents
Advertisement
Next steps
1
Reconnect all the disconnected cables.
2
Install the power supply units.
3
Follow the procedure listed in
Related links
Installing a power supply unit
Chassis management board
Figure 40. Chassis management board
1
fan cage 1 connector for fans 1 and 2
3
chassis management board signal cable to backplane
5
chassis management board signal cable to PIB
7
MCU connector
9
firmware jumpers
11
fan cage 2 connector for fans 3 and 4
Removing the chassis management board
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the power supply units.
4
Remove the power interposer board.
5
Disconnect all the cables that are connected to the chassis management board.
After working inside your
system.
Safety
instructions.
Before working inside your
2
left midplane signal cable
4
chassis management board power connector from PIB
6
FPGA connector
8
COM connector
10
right midplane signal cable
system.
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
57
Hide quick links:
Advertisement
Table of Contents
