Philips FW-M55 User Manual page 14

CD / MP3-CD
Disc Change
You can change the outer two discs while
the third inner disc is stopped or is playing.
1 Press DISC CHANGE.
™ The disc carousel tray slides out.
2 Replace the discs in the left and right
disc trays.
• If you press DISC CHANGE again
during playback, the disc will stop
playing.
™ The disc carousel tray will rotate
until the inner tray is rotated out and
is ready for changing.
3 Press OPEN•CLOSE to close the disc
carousel tray.
Selecting a desired track
Selecting a desired track when
playback is stopped
• Press digit 0 – 9 on the remote control
to select the desired track.
™ Playback will start immediately for
the selected track.
™ The selected track number and
elapsed playing time appear on the
display.
14
FWM55-22-GB-ENG-V01 14
Selecting a desired track during
playback
• Press í or ë (or digit 0-9 on the
remote control) until the desired track
appears on the display.
™ The selected track number and
elapsed playing time appear on the
display.
• If you press í once it will skip to the
beginning of the previous track and play
the track.
For MP3-CD only
1 Press ALBUM - - /+ - - - + until the desired + + +
Album appears on the display.
2 Press TITLE - - - - /+ - + + + until the desired +
Title appears on the display.
™ The selected track number and
elapsed playing time appear on the
display.
3 Press PLAYÉ Å to start playback.
Searching for a particular
passage during playback
• Press à or á until the desired
passage is located.
™ The volume will be reduced.
• Press PLAYÉ Å to resume normal
playback.
Programming Tracks
Programming tracks of a loaded disc is
possible when playback is stopped. The
display will indicate the total tracks stored
in the program. Up to 99 tracks can be
stored in the memory in any order. When
99 tracks are stored and you attempt to
store another track, the display will show
"FULL".
1 Load the desired discs in the disc trays.
2 Press the CD (CD 1•2•3) button to
select the disc tray.
™ Programming can only be done on the
selected disc.
3 Press PROG to start programming.
™ The starts flashing.
PROGRAM
™ It will cancel any previously
programmed tracks and selected
repeat mode.
4 Pressí or ë (or digit 0-9 on the
remote control) to select the desired
track.
• For MP3-CD, press ALBUM - - - - - /+ + + + +
and TITLE - - - /+ - - + to select the + + +
desired Album and Title for
programming.
5 Press PROG to store the track.
• Repeat steps 4 to 5 to store other
tracks.
6 Press Ç once to end programming.
™ The total number of tracks
programmed and total playing time
appear on the display.
12/8/00, 1:57 PM
Notes:
– For MP3-CD, total playing time will not
be shown.
– If the total playing time is more than
" 99:59 " then " --:-- " appears on
the display instead of the total playing
time.
– If the system is reading the disc,
programming is not possible,
" READING DISC " will be
displayed.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Reviewing the program
Reviewing of program is possible only
when playback is stopped.
1 Press í or ë repeatedly to review
the programmed tracks.
2 Press Ç to exit review mode.
3139 115 20071