Communication Setting Contents - Mitsubishi Electric GT14 User Manual

11.1.3

Communication setting contents

This section describes setting items and display contents for Communication Setting.
(1) Channel-Driver assign
Channel No. can be assigned to the communication driver installed in the GOT.
(a) Not writing [Communication Setting] in drawing software
Without writing [Communication Setting] in drawing software, communication with a controller is available
after assigning the channel No. with this function.
(b) When changing the assignment of the communication driver to the channel in the Utility
Without using drawing software, the assignment of communication drivers to channels can be changed.
(When changing a communication driver, the alternative communication driver has to be installed in GOT in
advance.)
(2) Standard interface display BOX
Display the communication interface included as standard in GT14 Handy.
There are the following 4 types.
*1
RS-232 ................. For communicating with controller
*1
RS-422 ................. For communicating with controller
*1
Ethernet ................ For communicating with PC (GT Designer3), controller
USB......................... For communicating with PC (GT Designer3)
*1 These cannot be used simultaneously.
11 - 2
11. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
11.1 Communication setting
(3)
(3)
(3)
(5)
11.1.4 ■Channel-Driver assign operation
Ethernet interface
RS-232 interface
RS-422 interface
(2)
(4)
(2)
(4)
(2)
(4)
(2)
(4)
(1)
(6)
USB