Table of Contents
Advertisement
7-2. Connecting Load Cables
WARNING : ELECTRIC SHOCK
Before connecting or disconnecting the load cables to/from the output
terminal, always turn the output circuit breakers to the OFF position, stop the
engine, and remove the engine key.
The person performing the maintenance should always keep the key.
Close the output terminal cover before operating.
Do not touch the generator if the Alternator or casing becomes wet during
operation.
CAUTION : FIRE
Do not connect the generator output to indoor wiring.
< Note >
When connecting a load, check that the generator output setting, output terminal connection
position, and load power source are all matching.
If using the O terminal, be careful that the currents of each phase are uniform.
Use proper tools when connecting a load to sufficiently tighten the connection. Failure to
sufficiently tighten the connection will result in cable burnout.
(1) 3-Phase Output Terminal
For 3-phase load:
Terminal voltage is 400/440 V [200/220 V] (50/60Hz).
* The values in brackets are for when set to 200/220V.
For 1-phase load:
Terminal voltage is 230/254 V [115/127 V] (50/60Hz).
* The values in brackets are for when set to 200/220V.
R
S
T
Load
R
S
T
Load
17
O
O
Advertisement
Table of Contents
