Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; First Time Installation - Vox LED SMART39ST2880 Operating Instructions Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Press button. Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
To Switch the TV Off
Press the " " button on the remote control or press
the button or hold the control switch on the Tv
until shut down, so the TV will switch to standby mode.
(Depends model)
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type. Use "
Available search types are Digital and analog, digital
Aerial or Cable
only and analog only. When set, press "
Teletext Language. Use "
"Teletext Language" and select "Scan Encrypted" using
"
Yes if you want to scan coded stations.
Deafult PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
English - 8 -
" or " " button to highlight the required
" or " " to set the desired search type.
" or " " button. You can set Scan Encrypted as
" or " " button to set the
" button to select Search
" to select
" or " " button to set the