Daikin B-Series Service Manual page 112

Si12-714
Outdoor Unit
18
Indoor Unit
1. Air filter
2. Photocatalytic deodorizing filter
or Air-Purifying filter:
• These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. INTELLIGENT EYE sensor:
• It detects the movements of people and auto-
matically switches between normal operation
and energy saving operation.
8. Display
9. Air outlet
10. Flaps (horizontal blades):
11. louvers (vertical blades):
• The louvers are inside of the air outlet.
Outdoor Unit
17. Air inlet: (Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
Appearance of the outdoor unit may differ from some models.
Operation Manual
17
12. Indoor Unit ON/OFF switch:
13. Operation lamp (green)
14. TIMER lamp (yellow):
15. INTELLIGENT EYE lamp (green):
16. Signal receiver:
21. Earth terminal:
22. Outside air temperature sensor:
22
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
Temperature
Mode
setting
COOL 22°C
• This switch is useful when the remote controller
is missing.
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
• It is inside of this cover.
• It senses the ambient temperature around the
unit.
Instruction
19
20
21
Air flow
rate
AUTO
101