Please Read Immediately; Important Information; Intended Use; Regulations / Safety Information - Dimplex BWP 30 HS Installation And Operating Instructions Manual

1
1 Please read
immediately

1.1 Important information

ATTENTION!
Read these installation and
commissioning!
ATTENTION!
Work on the domestic hot water heat pump is to be performed by
qualified personnel only! Observe accident prevention regulations!
ATTENTION!
When installing the on-site pipework, ensure that the pipes are not
contaminated (flush pipes before connecting the domestic hot water heat
pump if necessary)!
ATTENTION!
The device cover cannot be used for carrying (the cover cannot withstand
larger forces!)
ATTENTION!
The domestic hot water heat pump must only be operated when filled with
water!
ATTENTION!
The collector sensor must be a temperature sensor with the resistance
characteristic curve of a PT1000.
ATTENTION!
Disconnect the power supply before opening the domestic hot water heat
pump; possible fan coasting must be considered!
ATTENTION!
Risk of injury caused by sharp-edged fins. Fins must not be deformed or
damaged!

1.2 Intended use

This device is only intended for use as specified by the
manufacturer. Any other use beyond that intended by the
manufacturer is prohibited. This requires the user to abide by the
manufacturer's product information.
tampering with or altering the device.
1.3 Regulations / safety
information
ATTENTION!
Read these installation and
commissioning!
The domestic hot water heat pump is exclusively used to
heat water for domestic use and drinking water within the
specified operating temperature limits! The heating of fluids
other than domestic water is not permitted. The technical
regulations for domestic water installations (DIN 1988) are
to be observed.
EN-2
operating instructions before
Please refrain from
operating instructions before
The following is not permitted:
Operating the pump with solvent-based or explosive
-
exhaust air
- The use of exhaust air containing grease, dust or aerosols
containing adhesive substances
- The connection of extractor hoods to the
ventilation system
It is not permissible to install the device:
- outdoors
- in rooms which are exposed to frost
- in rooms subject to high humidity (e.g. bathrooms)
- in rooms with air which is potentially explosive
due to gases, vapours or dust
It is not permissible to operate the device:
- with an empty cylinder
- during building construction
The construction and design of the domestic hot water heat
pump complies with the relevant EC directives. (see also CE
declaration of conformity).
The technician must ensure that the refrigerant is flushed
adequately to allow maintenance and repair work to be
carried out on refrigeration circuit components without risk.
Refrigerant must be properly handled and disposed of; it
must not be released into the environment!
The refrigeration circuit is hermetically sealed. It contains
the Kyoto protocol-approved fluorinated refrigerant R134a
with a GWP value of 1300. It is CFC-free, does not deplete
ozone and is non-flammable.
Always disconnect the power supply before carrying out any
work on the domestic hot water heat pump.
When connecting the domestic hot water heat pump to the
power supply, the relevant VDE, EN and IEC standards
must be fulfilled. Also observe the technical connection
requirements of the electrical utility companies.
This heat pump is designed for use in a domestic
environment according to Article 1, Paragraph 2 k) of EC
directive 2006/42/EC (machinery directive) and is thus
subject to the requirements of EC directive 2006/95/EC
(low-voltage directive). It is thus also intended for use by
non-professionals for heating shops, offices, hotels and
other similar working
establishments and hotels,
residential buildings.
ATTENTION!
Work on the domestic hot water heat pump is to be performed by
qualified personnel only!
Observe accident prevention regulations!
environments, agricultural
guesthouses and other