Nikon D100 VBA10201 Repair Manual page 75

(3) Select "CCD GrGb level compensation adjustment" in "Contents" on the menu display.
(4) Supply the power to the camera through the AC cable.
(5) Connect the USB cable to the camera.
(6) Set the tool lens (fixed aperture is F8, without ND filter) onto the camera.
(7) Set the camera onto the luminance surface of the color viewer with nearest distance.
(8) Press the START button. Perform the procedure according to the instructions on the screen.
(According to the instructions on the screen, move the camera to the center of red chart and blue chart. Look
into the finder to make sure that the whole screen is the color of chart.)
(9) The adjustment result is displayed at the result display position. If "OK" is displayed, the adjustment is
normally ended. If the adjustment is NG, "NG" is displayed and the contents of the error are displayed in
the column of "COMMENT".
(10) Remove the USB cable from the camera and then remove the AC cable.
• Color sensitivity ratio adjustment
*Before adjustment, acquire the sensitivity reference value and color sensitivity ratio reference value by using
the reference body. (Refer to the following description for the procedure.)
(1) Set the luminance of the color viewer to "LV13".
(2) Select "Color sensitivity ratio adjustment" in "Contents" on the menu display.
(3) Supply the power to the camera through the AC cable.
(4) Connect the USB cable to the camera.
(5) Set the tool lens (fixed aperture is F8, with ND3 filter) onto the camera.
(6) Set the camera onto the luminance surface of the color viewer with nearest distance.
(7) Press the START button. Perform the procedure according to the instructions on the screen.
(8) The adjustment result is displayed at the result display position. If "OK" is displayed, the adjustment is
normally ended. If the adjustment is NG, "NG" is displayed and the contents of the error are displayed in
the column of "COMMENT".
(9) Remove the USB cable and then remove the AC cable.
[Acquirement of the sensitivity reference value and color sensitivity ratio reference value by using the reference body]
(1) Set the luminance of the color viewer to "LV13".
(2) Click "Sensitivity reference value calculation" on the menu display.
(3) Supply the power to the camera through the AC cable.
(4) Connect the USB cable to the camera.
(5) Set the tool lens (fixed aperture is F8, with ND3 filter) onto the camera.
(6) Set the camera onto the luminance surface of the color viewer with nearest distance.
(7) Perform the procedure according to the instructions on the screen.
(8) After ending the procedure, remove the USB cable and AC cable from the camera.
(9) Carry out the procedure for the color sensitivity ratio reference value in the same way as the above.
- A45 ･ -
VBA10201-R.3577.A