Nikon D100 VBA10201 Repair Manual page 3

EXPOSURE
Metering
Matrix
Center-weighted
Spot
Range
Exposure meter coupling Combined CPU and AI
Exposure control
Exposure lock
Shutter
Speed
Sensitivity
White balance
Built-in Speedlight
Guide number
Illuminating angle
FLASH
Sync contact
Flash control
Flash sync modes
Flash-ready light
Accessory shoe
Three-mode through-the-lens (TTL) exposure metering
3D matrix metering supported with type G and D lenses;
matrix metering available with other lens types
Weight of 75% given to 8-mm circle in center of frame
Meters 4-mm circle in center of frame; with CPU lens,
metered area linked to selected focus area
0 – 21 EV (3D matrix or center-weighted metering)
3 – 21 EV (spot metering)
(ISO 100 equivalent,f/1.4 lens, 20°C/68°F)
Programmed auto with flexible program; shutter-priority
auto; aperture-priority auto; manual; exposure compensation
(–5 – +5 EV in increments of 1/3 EV); auto
bracketing (2 or 3 exposures in steps of 1/3 or 1/2 EV)
Locked at detected value with AE-L/AF-L button
Combined electronic (CCD) and mechanical shutter
30 – 1/4000 in 1/3 EV steps, long time-exposure (bulb)
200 – 1600 (ISO equivalent) in steps of 1/3 EV; auto gain to ISO 1600 equivalent
TTL white balance control with white balance bracketing
Pop-up Speedlight with button release
Guide number 12/39 (ISO 100, m/ft)
Same as 20-mm lens
X-contact only; flash synchronization at up to 1/180 s
• Automatic balanced fill flash controlled by five-segment TTL multi sensor with
single-component IC.
Supports 3D multi-sensor balanced fill flash for digital SLR (built in Speedlight or SB series
80DX/50DX/28DX with type G or D lens) and multi-sensor balanced fill flash for digital SLR
(built in Speedlight or SB series 80DX/50DX/28DX with other CPU Nikkor lens)
• Non-TTL auto
Front-curtain sync (normal), red-eye reduction, red-eye reduction with slow sync, slow sync,
rear curtain
Lights when built-in Speedlight or SB-series 80DX, 50DX, 28DX, 28, 27, or 22s is fully
charged; blinks for three seconds after flash is fired at full output
Standard ISO hot-shoe contact with safety lock
- Ｍ2 ･ -
VBA10201-R.3577.A