Electrical Connection; Attention; Electrical Requirements; Fitting A Different Plug - Beko DPH 8756 W User Manual

4

Electrical Connection

Make sure that you have an earthed power
outlet socket rated at 13 amps (minimum).

4.1 Attention!

When installed, the socket must be reachable
after installation, or a separate switch (which
can disconnect the two poles) must be used
in the installation. Check for suitability.For a
permanent connection, a master switch with
at least 3mm contact clearance and minimum
13 A rating must be used.

4.2 Electrical requirements

Before you insert the plug into the wall sock-
et make sure that the voltage and the fre-
quency shown in the rating label corresponds
to your electricity supply.
We recommend that this appliance be con-
nected to the mains supply via a suitable
switched and fused socket in a readily acces-
sible position. Should the mains lead of the
appliance become damaged or need replac-
ing at any time, it must be replaced by a spe-
cial purpose made mains lead which can only
be obtained from a Authorised Service Agent.
A
Warning
This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
The moulded plug on this appliance incorpo-
rates a 13A fuse. Should the fuse need to be
replaced an ASTA approved BS1362 fuse of
the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing
the fuse cover, the plug must not be used un-
til a replacement fuse cover has been fitted.
Colour of the replacement fuse cover must
be the same colour as that visible on the pin
face of the plug. Fuse covers are available
from any good electrical store.
In order to avoid hazards, damaged supply
cord should be replaced by the manufacturer,
its service agent or similarly qualified people.
Built-under installation
This appliance can be installed under a work-
top.
A
Do not operate without the top
cover fitted. Risk of injury.
Dryer / User Manual
A
Important

4.3 Fitting a different plug

As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals on your plug, proceed as follows:
1 Connect the green - yellow or green (earth)
wire to the terminal in the plug marked 'E' or
with the symbol or coloured green and yel-
low or green.
2 Connect the blue (neutral) wire to the ter-
minal in the plug marked 'N' or coloured black.
3 Connect the brown (live) wire to the termi-
nal in the plug marked 'L' or coloured red.
Green and yellow
N
Blue or black
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or in
the main fuse box. If in doubt contact a quali-
fied electrician.

4.4 Washer/dryer combination

Do not stack washing machine on top of the
tumble dryer. This would damage both appli-
ances and guarantees would become void.
It is also unsafe to stack an appliance on top
of another without using a suitable and ap-
proved stacking kit obtained from the manu-
facturer of the appliances.
• A special stacking kit is required as an op-
tional extra please contact customer service.
or green
L
Brown or red
17 / EN