Panasonic KX-FG2452CX Service Manual page 98

KX-FG2452CX
• The ink film is empty. Replace the ink film with a new one.
• The ink film is slack. Tighten it (See step 5 on Installing the
Ink Film (P.69).) and install again.
• The fax machine is positioned near appliances such as TVs
or speakers which generate an intense magnetic field.
• The remaining ink film is low. Prepare a new ink film.
(Refer to Optional Accessories (P.9).)
• The phonebook copy stopped because the destination cord-
less handset was out of range. Press [STOP] to clear the
message.
• When making a copy, the document being stored exceeded
the memory capacity of the unit. Press [STOP] to clear the
message. Divide the document into sections.
• There is no room left in memory to record voice messages.
Erase unnecessary messages.
• There is something wrong with the unit's modem.
(Refer to Test Mode (P.77) and Digital Board Section
(P.141).)
• The other party's fax machine is busy or has run out of
recording paper. Try again.
• You tried to copy your phonebook items to the cordless
handset, but your phonebook was empty.
• Please use genuine Panasonic replacement film.
(Refer to Optional Accessories (P.9).)
• The ink film is slack. Tighten it (See step 5 on Installing the
Ink Film (P.69)) and install again.
• The fax machine is positioned near appliances such as TVs
or speakers which generate an intense magnetic field.
• A recording paper jam occurred. Remove the jammed paper.
(Refer to Recording Paper Jams (P.214).)
• You forced the recording paper into the paper tray too
strongly. Remove all of the installed paper, and re-install it
gently.
• There is no space to store new items in the phonebook.
Erase unnecessary items.
• The phonebook memory of the cordless handset is already
full, or became full when copying phonebook items. Copying
was stopped. Press [STOP] to exit the mode. Erase other
stored items in the cordless handset phonebook, then try
again.
• The unit is checking that there is no slack or crease in the ink
film. Wait for a moment while the check is completed.
• You recorded your greeting message or memo message
less than 1 second in length and recording has failed. Try
again.
• The other party's fax machine is busy or has run out of
recording paper. Try again.
• The document is jammed. Remove the jammed document.
(Refer to Document Jams - sending (P.215).)
• Press [STOP] to eject the jammed paper.
• There is something wrong with the unit and the base unit will
not work.
(Refer to Digital Board Section (P.141).)
• A transmission error occurred. Try again.
• If you send a fax overseas, try the following:
—Make sure the other party's number is a fax number.
—Use the overseas transmission mode (feature #23 on Pro-
gram Mode Table (P.123)).
—Add 2 pauses at the end of the telephone number or dial
manually.
• The unit is too hot. Stop using the unit for a while and let the
unit cool down.
98