Hoshizaki F-330BAH Service Manual page 43

6) Lift up the top insulation and unsnap the
bin control assembly. Lift the assembly up
through the insulation and set it aside. See
Fig. 7.
7) Remove the top insulation.
8) Remove the thumbscrews attaching spout
(B) to the bin, then remove spout (B). See
Fig. 8.
9) Remove the thumbscrews attaching
spout (A) and safety bracket (A) to the
evaporator assembly, then remove
spout (A) and safety bracket (A). See Fig. 8.
10) Pour the cleaning solution over the
extruding head until the evaporator
assembly and the reservoir are full and the
solution starts to overflow into the drain
pan.
Note: If there is excess scale on the
extruding head, fill the evaporator
assembly and reservoir as described
above, then use a clamp on the
reservoir hose between the reservoir
and evaporator assembly to block
flow. Pour additional cleaning fluid
over the extruding head until the
evaporator assembly is completely
full.
11) Allow the icemaker to sit for about
10 minutes before operation. If you placed
a clamp on the reservoir hose in step 10,
remove it before operation.
1) Replace all parts in their correct positions.
Make sure safety bracket (A) is in position
as illustrated in Fig. 10.
13) Plug the unit back in. Move the flush switch to the "ICE" position and move the power
switch to the "ON" position. Replace the panels in their correct positions and allow the
unit to make ice using the solution until it stops automatically.
Note: This unit is designed to start operating when the water reservoir is full.
14) Remove the front panel.
15) Move the flush switch to the "FLUSH" position to drain the remainder of the solution.
16) After the solution has drained, move the flush switch to the "ICE" position.
17) Replace the front panel in its correct position.
18) Open the water supply line shut-off valve to supply water to the reservoir.
Top Insulation
Spout
Packing (A)
Spout (B)
43
Bin Control
Assembly
Fig. 7
Thumbscrew
Safety Bracket (A)
Spout (A)
Extruding
Head
Evaporator
Assembly
Cylinder
Packing
Thumbscrew
Fig. 8