Rack Mounting - Sony PWS-110RX1 Installation Manual

1-6. Rack Mounting

This process is not necessary if you do not mount this unit
into a rack.
This unit can be mounted to a 19-inch rack conforming to
the ANSI/EIA-310-D standard, which meets the following
conditions.
1. Hole pitch: Universal pitch
2. Mounting hole: M5 screw hole or square hole (□9.2 to
□10 mm)
3. Holes of the front and rear mount angles meet the
conditions 1 and 2 above.
4. The inner distance between these mount angles is
within a range of 600 to 750 mm.
5. A space of at least 10 mm is provided from the inner
end of each mount angle to the right and left sides
outward.
Front View
Mounting hole
15.875 mm
15.875 mm
Inside dimension
450 mm min.
Mounting dimension
465 mm ±1.6
This illustration is an example of M5 screw hole.
Top View
Mount angles
Inner end of mount angle
Inner end of mount angle
Inner distance 600 to 750 mm
Mount angles
Clearance
1-6 (E)
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
w
. To prevent toppling over the rack, fix it on the horizontal
c
. More than two person for rack mount.
. Use the specified rack mount kit.
. Fix the rack to the floor.
. After rack mounting, fix the unit to the rack securely.
. Entrust the installation to a specialized contractor.
Rack unit
44.45 mm
n
. When other equipment with built-in hard disk drive is
. Do not install the unit to the rack without exterior parts.
. Cables connected to the connector panel must be long
. To suppress the internal temperature rise of the unit,
. Adjust the temperature inside the rack within the range
and firm floor securely with bolts or some anchoring
materials.
If you perform rack mount alone, you can hurt your back.
The use of other kit of low strength may drop the unit
and cause the risk of injury.
When the rack turns over with the heaviness of the unit,
it causes the death and the serious injury.
If the screws of rack angle are not fastened, the unit may
slip down and dropped from the rack, and you may get
injured. After rack mounting, be sure to tighten the
screws.
When mounting the unit to the rack, confirm the enough
strength, if not, the unit may be dropped and you may get
injured.
Installation to the rack, entrust to a specialized contrac-
tor.
already mounted in the same rack to which this unit is
going to be mounted. Turn off the power of the equip-
ment before mounting this unit.
enough to pull out the unit from the rack.
reserve a space of 4 cm or more on both sides and 10 cm
or more on the rear side between the rack and the unit.
(Refer to Fig. 1)
To ensure proper airflow, keep at least one of the four
spaces (up, rear, right, and left) at the rear of the unit so
as not to block airflow. (Refer to Fig. 2)
of the unit's operating temperature.
(Refer to Section 1-3)
PWS-110RX1