:Consider the points below before following the instructions
.Replace an existing or faulty hard drive with a hard drive of equal or greater capacity
.When handling hard drives, make sure that they are placed (and stored) on a cushioned surface
If you are replacing a 3.5-inch hard drive with a 2.5-inch hard drive, make certain to use the screws included
.with the NAS
Important info: The WSS NAS only accepts internal 3.5-inch SATA hard drives. Do not use 3.5-inch
hard drives built for external storage or SAS hard drives. Seagate hard drives are optimized for use
.with your NAS. See
Seagate NAS HDD
for further information
inch hard drive-3.5
Push the hard drive tray's lock button to open the latch and remove the hard drive tray. Important: Make .1
.certain that you remove the correct hard drive tray
.Insert a new hard drive or replace the current hard drive .2
.Empty tray: gently bend the left side of the tray and connect the hard drive to the two pins on the right
53
4/13/15
Seagate WSS NAS 2-Bay | 4-Bay | 6-Bay