Table of Contents
Advertisement
Disc can't be played
The player does not
respond to the remote
control
Distorted or B/W pic-
ture with DVD
No audio at digital output • Check the digital connections.
Player does not respond
to all operating com-
mands during playback
Cannot detect USB
plug-in
Switch between
DVD/USB
Player feels warm
Display goes dimmer
when AC is unplugged
• Ensure the disc label is upwards.
• Clean the disc.
• Check if the disc is defective by trying
another disc.
Aim the remote control directly at the
sensor on the front of the player. Avoid all
obstacles that may interfere with the signal
path. Inspect or replace the batteries.
Use only discs formatted according to the
TV-set used (PAL/NTSC).
• Operations are not permitted by the disc.
• Refer to the instructions in the disc inlay.
• Unplug the USB connection and plug-in
again. Detection may take some time that
vary with the capacity of your USB device.
• The DVD player only support Mass Storage
(MSC) format from USB flash drive.
• The DVD player does not support Hard
Disk storage or Media Transfer Protocol
(MTP) format.
• DVD mode is default source during the
DVD player power on.
• Plug in USB will activate USB mode.
Deactivate it by unplug the connection.
• Unplug the connection before you plug-
in another connection.
When the player is in use for a long period of
time, the surface will be heated.This is normal.
The unit is saving power to ensure longer
playtime with battery. It is normal. Adjust
the brightness in the SETUP menu.
Advertisement
Table of Contents
