Technical Data - Philips PDCC-XP-0845 User Manual

TROUBLESHOOTING
Symptom Remedy
Disc can't be played – Ensure the disc label is upwards.
– Clean the disc.
– Check if the disc is defective by trying another
The player does not – Aim the remote control directly at the
respond to the remote
control
Distorted or B/W – Use only discs formatted according to the
picture with DVD
Player does not respond – Operations are not permitted by the disc.
to all operating commands – Refer to the instructions in the disc inlay.
during playback
Player feels warm – When the player is in use for a long
Display goes dimmer when – The unit is saving power to ensure longer
AC is unplugged
This set complies with the radio interference requirements of the
European Union.
20
disc.
sensor on the front of the player. Avoid all
obstacles that may interfere with the signal
path. Inspect or replace the batteries.
TV-set used (PAL).
period of time, the surface will be heated.
This is normal.
playtime with battery. It is normal.
Adjust the brightness using the rotary bright
ness control.

TECHNICAL DATA

Dimensions
Weight
Power supply
Power consumption
Operating temperature range
Laser wavelength
Video system
Frequency response
Signal/noise ratio
Audio distortion + noise
Channel separation
Dynamic range
Audio out (analog audio)
Load impedance:
Video out Output level:
Load impedance:
PHILIPS reserves the right to make design and specification
changes for product improvement without prior notice.
Modifications not authorized by the manufacturer may void users
authority to operate this device.
All rights reserved.
210 x 158 x 39.5 mm
0.82 kg
INPUT: 100-240V 50/60Hz 0.3A
OUTPUT: DC 9V 1A
9W
0 - 45°C
650nm
PAL
20Hz ~ 20KHz ± 1dB
≥ 80dB
≤ -80(1KHz)
≥ 80dB
≥ 80dB
Output level: 2V ± 10%
10KΩ
1Vp - p ± 20%
75Ω