Configuring Global Parameters - Cisco ASR-920-24SZ-IM Installation Manual

Chapter 4 Initial Configuration
At the password prompt, enter your system password, as shown in the following example. If an enable
Step 4
password has not been set on your system, you can skip this step.
Password: enablepass
When your password is accepted, the privileged EXEC mode prompt is displayed:
Router#
You now have access to the CLI in the privileged EXEC mode. You can enter the necessary commands
to complete the required tasks.
Step 5 To exit the console session, enter the quit command, as shown in the following example:
Router# quit

Configuring Global Parameters

When you first start the setup program, configure the global parameters. These parameters are used for
controlling system-wide settings. Perform the following steps to enter the global parameters:
Step 1 Connect a console terminal to the console port, and then boot the router. For more information on
connecting a console terminal, see Connecting Console Cables section.
Note The following is only an example of the output display; prompts may vary.
When you see this information, it means that you have successfully booted your router:
The first sections of the configuration script appear only at an initial system startup. On subsequent uses
Step 2
of the setup facility, the script begins with a System Configuration Dialog as shown below: When you
are prompted about whether you want to enter the initial configuration dialog, enter yes.
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Would you like to enter the initial configuration dialog? [yes/no] yes
Configuring the Router at Startup
4-9