Table of Contents
Advertisement
GeneraL eMiSSiOnS Warranty cOVeraGe
a) The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser. The warranty period is two
years.
b) HFT warrants to the initial owner and each subsequent owner that the engine is:
1.
Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board; and
2.
Free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years.
c) The warranty on emissions‑related parts is as follows:
1.
Any warranted part that is not scheduled for replacement as required maintenance in the written instructions provided, is war‑
ranted for the warranty period stated above. If any such part fails during the period of warranty coverage, it will be repaired
or replaced HFT. Any such part repaired or replaced under the warranty will be warranted for the remaining warranty period.
2.
Any warranted part that is scheduled only for regular inspection in the written instructions is warranted for the warranty period
stated above. A statement in the written instructions to the effect of "repair or replace as necessary" does not reduce the period
of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period.
3.
Any warranted part that is scheduled for replacement as required maintenance in the written instructions will be warranted
for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled re‑
placement, the part will be repaired or replaced by HFT. Any such part repaired or replaced under warranty will be warranted
for the remainder of the period prior to the first scheduled replacement point for the part.
4.
Repair or replacement of any warranted part under the warranty will be performed at no charge to the owner at a retail store
or by HFT paying for shipping the product for repair.
5.
Notwithstanding the provisions herein, warranty services or repairs will be provided at all retail stores or by contacting HFT
product support at 1‑888‑866‑5797 or productsupport@harborfreight.com.
6.
The owner will not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective,
provided that such diagnostic work is performed at a retail store.
7.
HFT is liable for damages to other engine components proximately caused by a failure under warranty of any warranted part.
8.
Throughout the emissions warranty period stated above, HFT will maintain a supply of warranted parts sufficient to meet the
expected demand for such parts.
9.
Any replacement part may be used in the performance of any warranty maintenance or repairs and will be provided without
charge to the owner. Such use will not reduce the warranty obligations of HFT.
10. Add‑on or modified parts that are not approved by HFT may not be used. The use of any non‑exempted add‑on or modified
parts will be grounds for disallowing a warranty claim. HFT is not liable to warrant failures of warranted parts caused by the
use of a non‑exempted add‑on or modified part.
d) Emission Warranty Parts List.
1. Fuel Metering System
a. Carburetor and its internal parts (and/or pressure regulator
or fuel injection system).
b. Fuel tank.
c. Cold start enrichment system.
d. Air/fuel ratio feedback and control system.
2. Air Induction System
a. Controlled hot air intake system.
b. Intake manifold.
c. Air filter.
3. Ignition System
a. Spark plugs.
b. Magneto ignition system.
c. Spark advance/retard system.
HFT provides with each product written instructions for the maintenance and use of the product by the owner.
3491 Mission Oaks Blvd. • pO Box 6009 • camarillo, ca 93011 • 1-888-866-5797
4. Catalyst System (if so equipped)
a. Exhaust pipe stud/exhaust manifold.
b. Thermal reactor.
c. Catalytic converter (if so equipped).
5. Particulate Controls
a. Traps, filters, precipitators, and any other device used to
capture particulate emissions.
6. Miscellaneous Items Used in Above Systems
a. Vacuum, temperature and time sensitive valves and
switches.
b. Hoses, belts, connectors, and assemblies.
7. Evaporative Emission Control System
a. Fuel tank.
b. Fuel caps, valves, canisters, filters, vapor hoses, clamps,
connectors, belts, and assemblies.
Advertisement
Table of Contents
