Alpine IVX-W200E Owner's Manual page 32

① Radio Antenna Receptacle
② REAR CAMERA Input RCA Connector (Yellow)
③ Video Output Connector (AUX OUTPUT) (Yellow)
Output the video.
④ HDMI Input Connector
Input HDMI signal, you should prepare an optional Alpine
special HDMI cable.
⑤ MFC Camera Connector (6 Pin)
Input Multi Function Camera signal.
You should prepare an optional Alpine special MFC.
⑥ SWC1 Connector
To steering remote control interface.
⑦ Interrupt In Connector
Connect this lead to the remote switch lead of your
interface box.
⑧ DTV REMOTE OUT
Connect this lead to the remote turn-on lead of your
interface box.
⑨ SWC2 Connector
To steering remote control interface.
⑩ SWC GND Connector
⑪ DTV GND Connector
Connect this lead to a good chassis ground on interface box.
⑫ Rear CAM Power 12V Out
Connect this lead to a rear cam.
⑬ Rear CAM GND
⑭ PARKING BRAKE
Connect this lead to the power supply side of the parking
brake switch to transmit the parking brake status signals to
the W200E.
⑮ Right Rear (+) Speaker Output Lead (Violet)
Right Rear (–) Speaker Output Lead (Violet/Black)
16
Right Front (+) Speaker Output Lead (Grey)
17
Right Front (–) Speaker Output Lead (Grey/Black)
18
Left Front (+) Speaker Output Lead (White)
19
Left Front (–) Speaker Output Lead (White/Black)
20
Left Rear (+) Speaker Output Lead (Green)
21
Left Rear (–) Speaker Output Lead (Green/Black)
22
ILLUMINATION+ Connector
23
ILLUMINATION- Connector
24
Radio Antenna Power / Ext. AMP ACC
25
Connect this lead to the +B terminal of your power antenna.
Connect this lead to the ACC terminal of your Ext. AMP.
AMP Remote Out
26
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Reverse Signal
27
Connect to the plus side of the car's reverse lamp. This
lamp illuminates when the transmission is shifted into
reverse (R).
Switched Power Lead (Ignition) (Red)
28
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)
12V only when the ignition is turned on or in the accessory
position.
Battery Lead (Yellow)
29
Connect this lead to the positive (+) post of the vehicle's
battery.
Ground Lead (Black)
30
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
PRE-OUT RCA Connectors (FRONT RIGHT)
31
It can be used as Front Output RCA Connectors.
RED is right.
PRE-OUT RCA Connectors (SUBWOOFER RIGHT / REAR
32
RIGHT)
It can be used as Rear Output RCA Connectors.
RED is right.
PRE-OUT RCA Connectors (SUBWOOFER LEFT / REAR LEFT)
33
It can be used as Rear Output RCA Connectors.
WHITE is left.
PRE-OUT RCA Connectors (FRONT LEFT)
34
It can be used as Front Output RCA Connectors.
Fuse Holder (10A)
35
32