Picture Tube Removal - Sony Trinitron KV-B14PD1 Operating Instructions Manual

2-4. PICTURE TUBE REMOVAL

# Degaussing coil
3 Two washer head screws
(BVTP 4 × 16)
4 Speaker
block (L)
! Four tapping
screws (5)
5 Anode cap
• REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short curcuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
• REMOVING PROCEDURES
a
a
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
9 Tension spring
6 A board
7 C board
8 Deflection yoke
1 Two screws
(BVTP 4 × 16)
" Picture tube
2 Speaker
block (R)
Cushion
b
2 Using a thumb press down then pull up the rubber cap firmly in the direction
indicated by the arrow b.
3 When one side of the rubber cap is separated from the anode button, the
anode-cap can be removed by turning up the rubber cap and pulling it up in the
direction of the arrow c.
•
HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects.
2 Do not press the rubber too hard so as not to damage the inside of anode-caps.
A metal fitting called the shatter-hook terminal is built into the rubber.
3 Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
b
c
Anode button