Lighting Features; Entry Lighting; Exit Lighting; Battery Power Protection - Cadillac CT6 2017 Owner's Manual

168 LIGHTING

Lighting Features

Entry Lighting

Some exterior lamps and most of the
interior lights turn on briefly at night,
or in areas of limited lighting when
is pressed on the Remote Keyless
Entry (RKE) transmitter. See Remote
Keyless Entry (RKE) System Operation
0 28. When the driver door is opened,
all control lights, Driver Information
Centre (DIC) lights, and door pocket
lights turn on. After about 30 seconds
the exterior lamps turn off, then the
remaining interior lights dim to off.
Entry lighting can be disabled
manually by changing the ignition out
of the OFF position, or by pressing
on the RKE transmitter.
This feature can be changed. See
Vehicle Locator Lights under Vehicle
Personalisation 0 150.
Entry Lighting with Approach
Detection
If equipped with approach detection,
the entry lighting feature will
automatically turn on when the RKE
transmitter is detected within
approximately 2 m (6 ft) of the
vehicle.
If the vehicle has remained parked for
an extended period of time with no
RKE transmitter use or Keyless Access
operation, approach detection will be
disabled. To reactivate, press any
button on the RKE transmitter or
open and close all vehicle doors to
re-enable the entry lighting feature on
approach.
Approach detection will not work if:
The vehicle battery is low.
The ignition is in ACC/ACCESSORY
or ON/RUN.
Entry lighting is set to OFF in
Vehicle Locator Lights . See
Vehicle Personalisation 0 150.
Approach detection will not work with
a single RKE transmitter if:
The RKE transmitter is left within
a 5 m (16 ft) range of the vehicle
for several minutes.
The RKE transmitter is left inside
the vehicle and all the doors are
closed.

Exit Lighting

Some exterior lamps and interior
lights come on at night, or in areas
with limited lighting, when the driver
door is opened and the turn signal
lever is pulled after the ignition is
turned off. The dome lamp comes on
after the ignition is changed to the
OFF position. The exterior lamps and
interior light remain on for a set
amount of time, then automatically
turn off.
The exterior lamps turn off
immediately by turning the exterior
lamp control off.
This feature can be changed. See
Vehicle Personalisation 0 150.

Battery Power Protection

The battery saver feature is designed
to protect the vehicle's battery.
If some interior lamps are left on and
the ignition is turned off, the battery
rundown protection system
automatically turns the lamp off after
some time.