D-Link DGS-1210-12TS/ME User Manual page 142

4 Configuration
ACL rule to limit traffic. The step of bandwidth is 64kbps. Due to limited metering rules, not all ACL rules can
associate with a metering rule.
Profile ID: The pre-configured Profile ID for which to configure the Flow Metering parameter.
Access ID (1-128): The pre-configured Access ID for which to configure the Flow Metering parameters.
Enter the appropriate information and click Find the entries will be displayed on the lower half of the table.
To edit and entry click the corresponding Modify button, to delete an entry click the corresponding Delete
button, to add a new entry click the Add button which will display the following window for the user to
configure.
Profile ID (1-6): Specify the profile ID.
Access ID (1-128): Specify the Access ID that will be used to configure the Flow Metering parameters, enter
a value between 1 and 128.
Mode: To be used the corresponding information.
- Rate: Specify the committed information Rate of the packet. The range is from 64 to 1024000
kbyte.
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.210 - ACL > ACL Flow Meter
Figure 4.211 - ACL > Add ACL Flow Meter
1 3 5
1 3 5