EdgeStar 18" Built-In Dishwasher
Troubleshooting
Follow the troubleshooting guide below to resolve common
issues.
Issue
Dishwasher does not
start
Water not pumped
from dishwater
Suds in tub
Stained tub interior
White film on
dishwasher interior
surface
Possible Cause
Fuse is blown or
circuit breaker is
tripped
Power Supply is
not turned on
Dishwasher door
is not properly
closed
Kink in drain hose
Filter clogged
Improper
detergent
Spilled rinse aid
Detergent used
contained
colorant
Hard water
minerals
Items are not
non-corrosive.
Solution
Replace fuse or reset circuit
breaker. Remove any other
appliances sharing the same
circuit with the dishwasher.
Ensure the dishwasher is
turned on and the door is
closed securely.
If applicable, make sure the
power cord is properly
plugged into the wall socket.
Close dishwasher, ensuring
that the door latches.
Check drain hose
Check coarse filter
Use only the specified
detergent. If improper
detergent was used, open
the dishwasher allowing suds
to evaporate. Add 1 gal. of
cold water to the tub. Close
and latch the door. Start the
"Rinse" wash cycle to drain
the water. Repeat if
necessary.
Always clean up rinse aid
spills immediately.
Do not use detergents with
colorants.
While wearing rubber gloves,
use a damp sponge to
clean the interior with
dishwasher detergent. Never
use any other cleaner to
clean dishwasher.
Do not place non-
dishwasher safe items in
dishwasher.
26