Reset Arp Detection Statistics - HP 5920 Command Reference Manual

ARP packets dropped by ARP inspect checking:
Interface(State)
XGE1/0/1(U)
XGE1/0/2(U)
XGE1/0/3(T)
XGE1/0/4(U)
Table 35 Command output
Field
State
Interface(State)
IP
Src-MAC
Dst-MAC
Inspect

reset arp detection statistics

Use reset arp detection statistics to clear ARP detection statistics.
Syntax
reset arp detection statistics [ interface interface-type interface-number ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Clears the ARP detection statistics for the specified interface.
Usage guidelines
If you do not specify any interface, this command clears the statistics of all the interfaces.
Examples
# Clear the ARP detection statistics of all the interfaces.
<Sysname> reset arp detection statistics
IP Src-MAC
40 0
0 0
0 0
0 0
Description
State of an interface:
•
U—ARP untrusted interface.
•
T—ARP trusted interface.
Inbound interface of ARP packets. State specifies the port state, trusted or untrusted.
Number of ARP packets discarded due to invalid source and destination IP addresses.
Number of ARP packets discarded due to invalid source MAC address.
Number of ARP packets discarded due to invalid destination MAC address.
Number of ARP packets failed to pass user validity check.
302
Dst-MAC Inspect
0 78
0 0
0 0
30 0