Digital Tuner - Philips AZ2536/01 User Manual

DIGITAL TUNER

RADIO RECEPTION
Tuning to stations
1. Press STANDBY ON y to on, then press SOURCE once or more to select FM/MW.
=
Display: shows waveband, frequency, and preset station number if already stored.
2. Tuning to stations: you can tune to your stations manually or by
automatic search tuning:
Press down on ∞ or § (5 or 6 on the remote control) and
release button when the frequency in the display starts running.
=
The radio automatically tunes to a station of sufficient
reception. Display shows
during automatic tuning.
Repeat step 2 if necessary until you find the desired station.
3.
To tune to a weak station, press ∞ or § (5 or 6 on the remote control) briefly and repeatedly
•
until you have found optimal reception.
Changing tuning grid (some versions only
In North and South America the frequency step between adjacent channels in the AM and FM band
are 10 KHz and 100 KHz respectively. In the rest of the world this step is 9 KHz and 50 KHz. Usually
the frequency step has been preset in the factory for your area if not
Select TUNER source.
1.
2. Press MODE on the set for at least 6 seconds.
= The display shows either
Helpful hints: All preset stations will be lost and need to be reprogrammed.
:
To improve radio reception:
• For FM, extend, incline and turn the telescopic antenna. Reduce
its length if the signal is too strong.
• For MW, the set uses a built-in antenna. Direct this antenna by
turning the whole set.
12
)
or
.
: