Cadillac CTS Owner's Manual page 303

302 VEHICLE CARE
compressor may be turned on/off
until the correct pressure is
reached.
If you inflate the tyre higher
than the recommended pressure
you can adjust the excess
pressure by pressing the pressure
deflation button (4) until the
proper pressure reading is
reached. This option is only
functional when using the air
only hose (7).
11. Press the on/off button (2) to
turn the tyre sealant and
compressor kit off.
Be careful while handling the
tyre sealant and compressor kit
as it could be warm after usage.
12. Unplug the power plug (8) from
the accessory power outlet in the
vehicle.
13. Disconnect the air only hose (7)
from the tyre valve stem, by
turning it anticlockwise, and
replace the tyre valve stem cap.
14. Replace the air only hose (7) and
the power plug (8) and cord back
in its original location.
15. Place the equipment in the
original storage location in the
vehicle.
The tyre sealant and compressor kit
has an accessory adapter located in a
compartment on the bottom of its
housing that may be used to inflate
air mattresses, balls, etc.
Removal and Installation of the
Sealant Canister
To remove the sealant canister:
1. Unwrap the sealant/air hose to
access the canister release
button.
2. Press the canister release
button (9).
3. Pull up and remove the canister.
4. Replace with a new canister
which is available from your
dealer.
5. Push the new canister into place.
6. Rewrap the sealant/air hose.
Storing the Tyre Sealant
and Compressor Kit
To access the tyre sealant and
compressor kit:
1. Open the boot. See Boot 0 38.
2. Lift the cover.