Table of Contents
Advertisement
MAINTAINING YOUR MODEL
Your model requires timely maintenance in order to stay in top
running condition.
The following procedures should be taken
very seriously.
Frequently inspect the vehicle for obvious damage or wear. Look
for:
1. Cracked, bent, or damaged parts
2. Check the wheels and steering for binding.
3. Check the operation of the shock absorbers.
4. Check the wiring for any frayed wires or loose connections.
5. Check the mounting of the receiver, servo, and speed control.
6. Check the tightness of the wheel nuts with a wrench.
7. Check the operation of the radio system, especially the
condition of the batteries.
8. Check for any loose screws in the chassis structure or
suspension.
9. Check the operation of the steering servo and ensure that it is not
binding.
10. Inspect the gears for wear, broken teeth, or debris lodged between
the teeth.
Other periodic maintenance:
• Chassis: Keep the chassis clean of accumulated dirt and grime.
Periodically inspect the chassis for damage.
• Suspension: Periodically inspect the model for signs of damage,
such as bent or dirty suspension pins, bent camber links, loose
screws, and any signs of stress or bending. Replace components
as needed.
• Steering: Over time, you may notice increased looseness in
the steering system. Replace any components as needed to restore
factory tolerances.
• Shocks: Keep the oil level in the shocks full. Use only 100%
pure silicone shock oil to prolong the life of the seals. If you are
experiencing leakage around the top of the shock, inspect the
bladder in the top cap for signs of damage or distortion from
overtightening. If the bottom of the shock is leaking, then it is time
for a rebuild. The Traxxas rebuild kit for two shocks is part #2362.
• Driveline: Inspect the driveline for signs of wear or any unusual
noise or binding. Remove the gear cover and inspect the spur
gear for wear and check the tightness of the set screw in the
pinion gear. Tighten, clean, or replace components as needed.
Note: When replacing the
spur gear, be sure the spur
gear is fully seated on the
center driveshaft as shown.
There will be an audible
"click" as the gear is pushed
into place.
Storage
When you are through running your model for the day, blow it off
with compressed air or use a soft bristled paint brush to dust-
off the vehicle. Always disconnect and remove the battery from
your model whenever the model is stored. If your model will be
stored for a long time, then also remove the batteries from the
transmitter.
Always wear eye protection
when using compressed
air or spray cleaners and
lubricants.
11
TRAXXAS • 27
Advertisement
Table of Contents
