Traxxas 83056-4 Owner's Manual page 15

RADIO SYSTEM CONTROLS
Neutral
RADIO SYSTEM RULES
• Always turn your transmitter on first and off last. This procedure
will help to prevent your model from receiving stray signals
from another transmitter, or other source, and running out of
control. Your model has electronic fail-safes to prevent this type of
malfunction, but the first, best defense against a runaway model is
to always turn the transmitter on first and off last.
1 2
Always turn your
Plug in the battery.
transmitter on first.
• Always use new batteries for the radio system.
limit the radio signal between the receiver and the transmitter.
Loss of the radio signal can cause you to lose control of your model.
• In order for the transmitter and receiver to bind to one another,
the receiver in the model must be turned on within 20 seconds
of turning on the transmitter. The transmitter LED will flash fast
red, indicating a failure to link. If you miss it, simply turn off the
transmitter and start over.
• Always turn on the transmitter before plugging in the battery.
RADIO SYSTEM BASIC ADJUSTMENTS
Throttle Neutral Adjustment
The throttle neutral adjustment is located on
the transmitter face and controls the forward/
reverse travel of the throttle trigger. Change
the adjustment by pressing the button and
sliding it to the desired position. There are
Brake/Reverse
two settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).
Note: We strongly recommend to leave this control in its factory
location until you become familiar with all the adjustments and
Forward
capabilities of your model. To change the throttle neutral adjust
position, turn the transmitter off before adjusting the neutral
position. You will need to reprogram your electronic speed control
to recognize the 70/30 setting. Turn to ESC Setup Programming on
page 18 for instructions.
Steering Trim
The electronic steering trim located on the
face of the transmitter adjusts the neutral
(center) point of the steering channel.
3
Note: Traxxas Stability Management (TSM) must be completely
turned off while adjusting steering trim. See page 17 for TSM
adjustments.
Multi-Function Knob
The Multi-Function knob can be programmed
Turn on the model. to control a variety of functions. From the
factory, the Multi-Function knob controls
Weak batteries will Traxxas Stability Management (TSM).
For more detail on TSM, refer to page 17.
TRAXXAS TQ 2.4GHz RADIO SYSTEM
i
Remember, always turn the
TQi transmitter on first and
off last to avoid damage to
your model.
Automatic Fail-Safe
The TQi transmitter and
receiver are equipped
with an automatic fail-
safe system that does not
require user programming.
In the event of signal loss
or interference, the throttle
will return to neutral and
the steering will hold its last
commanded position. If the
Fail-Safe activates while you
are operating your model,
determine the reason for
signal loss and resolve the
problem before operating
your model again.
Stop immediately at the first
sign of weak batteries. Never
turn the transmitter off when
the battery pack is plugged
in. The model could run out
of control.
6
TRAXXAS • 15