Selecting A Different Track; Finding A Passage Within A Track; Programming Tracks - Philips SOUNDMACHINE AZ1836 User Manual

MP3-CD/ CD Player
2 Press CD/USB to enter CD mode if USB
is displayed.
➜ Display will show --- (See 2).
3 Open the disc door.
4 Insert a disc with the printed side facing up
and press the disc door gently to close.
➜ Display:The total number of tracks
appears.
➜ The disc scanning of MP3-CD may run
longer than audio CD.
5 Press 2; to start playback.
➜ Display: 2 and the current track number.
For MP3-CD/ WMA only:
➜ The current track number "XXX" and
album number "ALB XXX" will be
displayed interchangeably (See 4 5).
6 To pause playback press 2;.
➜ Display: 2 and the current track number
flash.
7 Press 2; again to resume playback.
8 To stop playback, press 9.
Helpful hints:
The disc playback will also stop when:
– you open the disc compartment door;
– you select FM, MW or OFF position;
– the disc has reached the end of the playback.

Selecting a different track

• Press ∞ or § once or repeatedly until the
desired track number appears in the display.
For MP3-CD/WMA: First press
ALBUM+/- once or more to find your
album.
• In the pause/stop position, press 2; to start
playback.
Finding a passage within a
track
1 During playback, press and hold down
∞ or §.
➜ The disc is played at high speed and low
volume.
2 When you recognize the passage you want,
release ∞ or §.
➜ Normal playback resumes.

Programming tracks

You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1 In the stop position, press PROG to start
programming.
➜ Display shows P01 indicating the start
of
the program. PROG flashes. (See 6)
2 Press ∞ or § to select your desired track
number.
For MP3-CD/WMA: First press
ALBUM+/- once or more to find your
album.
3 Press PROG to store the desired track.
➜ Display shows P02, indicating the next
program location available.
4 Repeat steps 2 to 3 to select and store all
desired tracks.
5 Press 2; to play the program.
To review your program
In the stop position, press and hold PROG
3 seconds.
➜ The display shows all the stored tracks in
sequence.
Helpful hints:
– Display shows P01 if no track is
programmed.
– If you try to store more than 20 tracks, no
track can be stored and the display will show
FUL.