Hardware Installation - IOGear GUCE64 Quick Start Manual

GUCE64 Remote Unit
1. Power LED – Red (when Remote Unit is connected to the power adapter)
2. Device LED - Green (when a USB device is connected to Local Unit)
3. Link LED - Orange (when Local Unit is connected to Remote Unit over Cat5,
Cat5e, or Cat6 cable)
4. USB Type A Ports x 4
5. Power Port
6. RJ45 Port

Hardware Installation

1. Connect the GUCE64 BoostLinq Ethernet Local Unit to your computer, using the
included USB Type A to B cable. Plug the USB A end of the cable to your computer
and the USB B end to the GUCE64 Ethernet Local Unit. Power LED on Local Unit
should show red.
1
Power
2
Device
Link
3
Power
Device
Link
Local Unit
2
4
5 6