Servicing Notes - Sony HCD-HX50BTR Service Manual

HCD-HX50BTR/HX70BTR/HX80R/HX90BTR
Ver. 1.1
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostat-
ic break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The fl exible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc refl ective surface by the objective lens in the optical
pickup block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
RELEASING THE ANTITHEFT LOCK
The disc tray lock function for the antitheft of an demonstration
disc in the store is equipped.
Releasing Procedure:
1. Press the [ ] button to turn the power on.
?/1
2. While pressing the [ CANCEL ] button, press the [
x/
ton unit "UNLOCKED" displayed on the fl uorescent indicator
tube (around 5 seconds) .
Note: When "LOCKED" is displayed, the tray lock is not released by
turning power on/off with the [ ? / 1 ] button.
NOTE THE IC904 ON THE BT BOARD REPLACING
When IC904 cannot exchange with single. When IC904 is dam-
aged, exchange the entire mounted board.
4
SECTION 1

SERVICING NOTES

MODEL IDENTIFICATION
– Back Panel –
HX50BTR: AEP model
HX50BTR: Canadian model
HX50BTR: Russian model
HX50BTR: Singapore model
HX50BTR: Korean model
HX50BTR: Mexican model
HX50BTR: Chilean and Peruvian models
HX50BTR: Argentina model
HX50BTR: Brazilian model
HX70BTR
HX90BTR
HX80R
] but-
Z
PART No.
Model
3-284-497-0[]
3-284-497-1[]
3-284-497-2[]
3-284-497-3[]
3-284-497-5[]
3-284-497-7[]
3-284-497-8[]
3-284-497-9[]
3-290-773-0[]
3-290-773-1[]
3-290-773-2[]
3-290-773-3[]
Part No.