Table of Contents
Advertisement
XM Radio Operation, con't
3. Assign additional Channel Presets by performing
steps 1 and 2.
Note: If all 20 Presets are assigned and the STORE
Push-button is pressed, the display will indi-
cate the Channel selected for Preset Number
1. Refer to figure 47.
P20 XM50
PRESET 1: XM30
Figure 47
4. To verify the Preset(s) just entered into memory,
rotate the Front Panel PRESET/MENU Control or
use the PRESET
or PRESET
:
on the Remote Control.
Clearing Presets
5. Select the Preset to be removed by using the Front
Panel PRESET/MENU Control or by using the
PRESET
or PRESET
:
9
Remote Control.
6. Press and hold in the Front Panel STORE Push-
button until the Front Panel Information Display
indicates "PRESET CLEARED" then release the
STORE Push-button. Refer to figure 48.
26
Rock
¦
Push-buttons
9
7. To clear any additional Channel Presets perform
steps 5 and 6 again.
After the creation of Preset(s), use the Front Panel
PRESET/MENU Control to select the desired Channel
Preset or use the Remote Control PRESET
Push-buttons on the
SET
9
by pressing the PRESET Push-button followed by
entering the number of Preset using the 0-9 numeric
Push-buttons on the Remote Control.
XM25
Pop
\ Candle In The Wind
Figure 39
P20 XM50
Rock
PRESET CLEARED
Figure 48
Notes: 1. To exit without clearing a Preset from
memory, momentarily press the Front
Panel EXIT (STORE) Push-button.
2. If you wish to replace an already as-
signed Channel Preset with another XM-
Channel, it is not necessary to clear the
Preset first, just enter in the new Channel
for that Preset. The new Channel will
automatically replace the previously as-
signed Channel.
Push-buttons. Direct access is also possible
¦
Category Tuning
¦
The Category Tuning on the MR88 allows for selec-
tion of XM Channels with similar type of music (Pop,
Rock, Jazz, Classical, etc.) or program type such as
(Sports, Talk Shows, Traffic, etc.). Perform the follow-
ing steps to use Category Tuning:
1. Press the Front Panel CATEGORY Push-button or
the MODE Push-button on the Remote Control.
Refer to figures 39 and 25. The LED above the
CATEGORY Push-button will illuminate. The Sec-
ond Row of the Front Panel Information Display
will now indicate the current music/program type.
Refer to figure 49.
or PRE-
:
2. Press the Front Panel CATEGORY/SEEK Upp or
Downq Push-buttons or use the SEEK
SEEK
up the dial Push-buttons on the Remote
8
Control to select the desired Category Type. Refer
to figure 50.
3. Once the Category has been selected, either use the
Front Panel TUNE/ADJUST Control or the Upp
or Downq directional Push-buttons on the Remote
Control to select the desired XM Channel within
the selected Category Type. Refer to figures 51 and
52.
XM20
Pop
¦
Pop
Figure 49
7 down or
XM20
Pop
JzStndrd
Figure 50
XM71
JzStndrd
Watercolors
Figure 51
Advertisement
Table of Contents
