How To Use The Remote Control - McIntosh MR88 Owner's Manual

How to use the Remote Control

The Remote Control is capable of performing basic
Operating Functions for the MR88 AM/FM/XM/HD
Tuner.
Note: Refer to the "How to Operate" Section of this
manual for additional information using this
Remote Control, starting on page 20.
Manual Tuning
Use the BAND Push-button to select AM, FM or XM.
Press the DIRECTIONAL Upp or Downq Push-
button to move from station to station (AM or FM) or
from channel to channel (XM).
Automatic Tuning
Use the BAND Push-button to select AM, FM or XM.
Press the SEEK up the dial Push-button
7 down or 8
to move to the next station (AM or FM) or to the next
channel (XM).
Preset Tuning
Use the BAND Push-button to select AM, FM or XM.
Press the PRESET 9 down or : up the dial Push-
button and the MR88 will stop on the next Station,
Program or Channel in Preset Memory.
Note: For information on entering a Channel, Station or
Program into memory, refer to pages 21 and 25.
Direct Preset Access
To access the desired Station, Program or Channel
previously assigned to a Preset stored in memory,
perform the following:
1. Press the BAND Push-button to select AM, FM or
XM desired Preset.
2. Press the PRESET Push-button.
3. Using the 0 through 9 numeric Push-buttons enter
the Preset Number.
Note: When selecting a Preset 1 through 9 and
there are more than ten Presets entered into
memory for the given Band (AM, FM or XM)
there is a two second delay before the MR88
will go to the single digit Preset.
Direct Station or Channel Access
To access a desired Station or Channel perform the
following:
1. Press the BAND Push-button to select AM, FM or
XM desired Preset.
2. Using the 0 through 9 numeric Push-buttons enter
the Frequency Number of the Station (for AM or
FM) or the Channel Number (for XM).
Note: When entering a FM Station, there is no need
to enter the decimal point.
Selecting FM HD Radio Programs
To access a desired Program on a FM HD Radio
Broadcast perform the following:
1. Press the BAND Push-button to select FM.
2. Using the SEEK
7 down or 8
buttons or the DIRECTIONAL Upp or Downq
Push-button to select the desired HD Station.
3. Once the MR88 Tuner HD indicator illuminates,
select the desired Program by using the DIREC-
TIONAL Left ◄ or Right ► Push-buttons.
Selecting XM Catergory
To access a desired Category on XM perform the fol-
lowing:
1. Press the BAND Push-button to select XM.
2. Press the MODE Push-button to activate the Cat-
egory Mode.
3. Select the desired Category by using the SEEK
down or up Push-buttons.
8
Press the DIRECTIONAL Upp or Downq Push-
4.
button to select the desire XM Channel.
up the dial Push-
7
How to use the Remote Control
13