Echo SRM-22GES Operator's Manual page 6

Indoor
operation
SRM-22GES
Start on ground with cutting
attachment in the clear
AREA AND EQUIPMENT INSPECTION
Inspect the area before using the unit. Remove objects the
unit could throw. Remember where there are obstructions
to be avoided.
Inspect the unit before using it. Perform only maintenance
or adjustments for which the operator's Manual gives
instruction. Do not try to repair the unit without proper
instruction. The unit should be serviced only by trained
ECHO dealer servicemen with the proper tools.
Be sure that :
a) Engine does not leak fuel.
b) Fasteners are tight, and none are missing.
c) Silencer is in good condition.
d) The unit has the proper equipment-shield, handles,
etc.-for the cutting attachment to be used.
e) If used on the unit, the cutting attachment is properly
tightened.
• IMPROPER FIT WILL RESULT FLY OFF THE
CUTTING ATTACHMENT.
• NEVER START THE ENGINE IF THE POWER
TRANSMISSION SHAFT IS NOT IN PLACE TO
PREVENT THE ENGINE FROM OVER SPEEDING
OR THE CLUTCH FROM FLYING APART.
GENERAL OPERATION
Do not run the engine indoors, or where there is poor
ventilation. Engine fumes contain deadly poisonous carbon
monoxide.
Do not operate with a worn or damaged cutting attachment.
Do not run engine at full throttle without a load.
Do not hit rocks, stones, tree stumps, and other foreign
objects with the cutting attachment.
If cutting attachment strikes an obstruction, stop engine
immediately and inspect cutting attachment for damage.
Lay the unit down on a clear area and set the controls for
starting. Be sure the cutting attachment cannot contact the
ground or any obstruction.
Hold the unit firmly down so you will not lose control during
starting. Do not start the unit in the air. The unit could swing
into your leg or an obstruction if you lose control.
6
WARNING