Dish Network 20.1 User Manual page 28

Learning from Another
Device's Remote, continued
5
On the DISH Network remote, press and release
the button you want the DISH Network remote to
learn from the original device's remote. The Mode
light goes off and comes back on.
6
On the original device's remote control, press and
hold the button you want learned until the Mode
light goes out and comes back on. You may need
to press and hold the button on the original remote
several times before the DISH Network remote
learns the command.
• If the DISH Network remote learns the command,
the Mode light blinks off and then back on.
• If the Mode light blinks three times or remains
lit, the DISH Network remote did not learn the
command.
7
After a button has learned a command successfully,
repeat step 5 and step 6 until all commands you
want have been learned.
8
Press and release one of the Mode buttons on the
DISH Network remote to end the learning sequence.
This saves all the commands for that mode and exits
learning to return to normal remote control operation.
To cancel learning, do not press any buttons on
either remote control for at least 20 seconds. The
DISH Network remote control times out and returns
to normal operation.
Note: If the remote control batteries are too low
for learning, all the Mode buttons blink quickly
eight times. Learning ends without saving learned
commands, and the remote returns to normal
operation. Change the batteries and begin learning
again.
Note: No learned commands are saved if the DISH
Network remote control times out before completion.
26