Dish Network 20.1 User Manual page 27

Learning from Another
Device's Remote, continued
To have the DISH Network remote control learn specific
commands for another device, complete the following
steps.
1
Ensure the DISH Network remote control is working
with the receiver (see page 4 or 5).
2
Place both the DISH Network remote and the
original device's remote control on a flat, stable
surface. Point the front of the original device's
remote to face the small square (IR window) on the
front, left-hand side of the DISH Network remote, as
shown below. The remotes should be no more than
3" apart.
3
On the DISH Network remote, press and hold the
Mode button you want to use for the device until
all the Mode buttons light up (approximately three
seconds), and then release it. The selected Mode
button blinks continuously.
4
To start learning commands for this mode, select
one of the following choices:
• If you've found a code for the device and
programmed it into the remote, press and
release RECALL
when RECALL is pressed and comes on when
released), then hold the RECORD button
the Mode button is lit again (about three seconds).
The Mode button remains lit while learning.
• If the device code has not been programmed for
that device or if you are unable to find a code,
press and hold the RECORD button
the Mode button is lit (about three seconds). The
button remains lit while learning.
(the Mode light goes off
25
until
until