Table of Contents
Advertisement
Troubleshooting > Procedure for Removing Disc from Faulty DZ-MV380A
1) Turn the hood (a) in the direction of the
arrow to remove it. (See Fig. 4-8-1)
2) Remove three screws [A], and then remove
the filter piece (b). Be careful not to scratch
the lens surface with screwdriver at this
time.
3) Remove the lens cover (c) in the direction of
the arrow.
4) Remove the shoe cover in the direction of
the arrow.
5) Remove four screws [X].
6) Move the parts of the accessory shoe in the
direction of the arrow.
7) Insert a screwdriver, etc. into the hole in
accessory shoe at the top of product, and
move the lock arm (g) in the direction of the
arrow to open the disc loading block. (See
Fig. 4-8-2)
8) After removing the disc, close the disc
loading block to protect the disc drive unit.
When reinstalling removed components, use
the reverse procedure to removal.
9) After work, reinstall part of accessory shoe
and screws [X] to the accessory shoe: The
accessory shoe is set as a service part,
including screws [X].
(a) Hood
(b) Filter Piece
(c) Lens Cover
(d) Shoe Cover
(e) Parts of Accessory
Shoe
(f) Accessory Shoe
(b)
1
2 [A]
(a)
Fig. 4-8-1 How to Remove Disc
(g)
Fig. 4-8-2 How to Remove Disc
4 - 10
[A] M1.7×4 (Black)
[X] M2×2.5 (Black)
4
5 [X]
(d)
6
(e)
(c)
3
(g) Lock Arm
(f)
Advertisement
Table of Contents
