TP-Link Archer C55 User Manual page 54

Wireless Network Name - Also called the SSID (Service Set Identification). Enter a value of

up to 32 characters. The same name must be assigned to all wireless devices in your
network. Considering your wireless network security, the default SSID is set to be
TP-LINK_XXXX_5G. This value is case-sensitive. For example, TEST is NOT the same as
test.
Mode - Select the desired mode.

11an mixed - Select if you are using both 802.11a and 802.11n wireless clients. If you

set the Mode 11an mixed, all of 802.11a and 802.11n wireless stations can connect to
the router.
11a/n/ac mixed - Select if you are using a mix of 802.11a, 802.11n and 802.11ac

wireless clients. It is strongly recommended you set the Mode 11a/n/ac mixed, all of
802.11a, 802.11n and 802.11ac wireless stations can connect to the router.
Channel - This field determines which operating frequency will be used. The default channel

is set to Auto, so the router will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
Enable SSID Broadcast - When wireless clients survey the local area for wireless networks

to associate with, they will detect the SSID broadcast by the router. If you select the Enable
SSID Broadcast checkbox, the Wireless router will broadcast its name (SSID) on the air.
Enable WDS Bridging - Check this box to enable WDS. With this function, the router can

bridge two or more WLANs. If this checkbox is selected, you will have to set the following
parameters as shown in the following figure Make sure the following settings are correct.
Archer C55 AC1200 Wireless Dual Band Gigabit Router
- 49 -