How To Remove Parts - Hitachi R-S42CMJ How To Use Manual

Table of Contents

Advertisement

HOW TO REMOVE PARTS

Notice
● Make sure no stored items remain before removing a part.
● Do not remove parts which are not described below.
Contact with a service center listed on the back cover for cleaning parts after removing them.
Height adjustable upper and middle shelf
Slightly lift up the back
1
of the shelf and draw it.
When installing the shelf, slide it until it reaches to the interior wall, then slightly
lift up the back of the shelf and push it in. (hitch the forks of the shelf to the parts
on the back of the shelf)
Caution
Door may damage if drawing the shelf without turning it.
● Draw the shelf, and pull off
the two pins on the lower
right and remove it.
Height adjustable lower shelf
● Slightly lift up and pull out.
● Pull out the case to the full,
lift the front side slightly
and then remove it.
1
● Draw the door fully and pull up
the Spacious upper case as
shown in the fi gure.
48
Raise the shelf as shown in
2
fi gure, and turn it and remove it.
Fixed shelf
Chill room
Slide case
Vegetable Compartment
2
● Lift up the front part of the door,
and draw it further and incline it.
3
Frame
● Lift up the Lower Case.
● When installing it, insert the pins on the
left/right inner sides of the Lower Case
into the square holes on the frame, and
put the edge of the Lower Case on the
frame to install it.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R-s42cmjl

Table of Contents