Bulletin No: 09-036/14
© 2014 Mazda Motor of America, Inc.
18. Attach 3 pieces of the cut urethane pad to the back side of front door trim panel edge for the width indicated
by the red arrow (A).
NOTE:
•
Attach the pads so there is no clearance between the two.
•
Cut off the surplus of the last pad.
•
Since the pad has already been attached to this portion (B), there is no need to attach it.
19. Install a new front door trim. Refer to MS3 online or Workshop Manual (section 09-17 FRONT DOOR TRIM
REMOVAL/INSTALLATION).
20. Install a new front beltline molding. Refer to MS3 online or Workshop Manual (section 09-16 FRONT BELT-
LINE MOLDING REMOVAL/INSTALLATION).
21. Verify repair.
Last Issued: 08/29/2014
Page 12 of 16