Glass Media Installation / Removal; Optional Media Placement; Media Tray Removal - Napoleon LV38N-1 Installation Manual

11.8 glass media installation / removal

WARNING
!
• Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
• If replacing, use only the replacement glass media available from your local authorized dealer / distributor.
• Glass media over the burner ports will cause flame lifting and sooting problems.
• Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Evenly spread the glass media onto the media tray. Ensure no glass media falls into the pilot opening. If this
happens, insert a clean bag into your vacuum cleaner and vacuum out the glass media.
Replacement glass can be purchased from your local dealer / distributor.
note:
Do not use more media than what was supplied.
Do not place media directly onto the burner.
Cleaning Glass Media
Glass media may have a fine oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
Removing Media
Using a vacuum cleaner, use a clean bag and vacuum out the glass media.
11.9

optional media placement

To install optional media, refer to instruction leaflet included with the media kit.

11.10 media tray removal

If NOT using Shore Fire Kit (SFK), remove the media tray by removing the fasteners as shown.
Pilot Area
finishing
EN
53
W415-1709 / 06.30.17