Top Cap Installation - SRAM Reverb Stealth Service Manual

2 0 0 ( A 2 ) & 4 0 0 ( B 1 ) H o u r S e r v i c e T o p C a p I n s t a l l a t i o n
Apply a liberal amount of SRAM® Butter grease around the inside of a
1
new top cap assembly and onto the seals.
Use isopropyl alcohol and a shop towel to clean the outside of the
2
upper post.
Install the new top cap assembly, dust wiper seal end first, onto the
upper post assembly. Slide the top cap assembly down until it is
positioned below the upper post key slots.
Apply a light coat of SRAM Butter grease to the outside of the upper
post, above the top cap assembly.
NOTI CE
Ensure the dust wiper seal slides over the upper post without folding
the outer lip of the seal.

Top Cap Installation

28