Table of Contents
Advertisement
Step 3.
Carefully lay the compute node on a flat, static-protective surface, orienting the compute node
with the bezel pointing toward you.
Step 4.
Remove the cover (see "Removing the compute node cover" on page 105).
Step 5.
Pull the plunger of the 2.5-inch hard disk drive cage outward and rotate the cage upward.
2.5-inch Hard disk
drive cage
2
Figure 67. Lift the 2.5-inch hard disk drive cage upward
Step 6.
Push this latch gently outward a little to let the screw un-hold by the latch hole. Then, remove
the hard disk drive.
Release latch
1
Figure 68. 2.5-inch hard disk drive removal
Step 7.
Pull the plunger of the 2.5-inch hard disk drive cage outward and rotate the cage downward until
the cage snaps into place.
1
2
Chapter 5
.
Removing and replacing components
145
Advertisement
Table of Contents
Troubleshooting
